Hello,
This
is my truck. I am a welder and fabricator and a experienced
mechanic by trade. I would like to say that the only things on
this truck I didnt hand build were the tires, winch and front
coil springs. I even made some of the bolts myself! I take
great pride in this and hope you enjoy my truck.
Specifications:
1/4
elliptical rear suspension made from the rear leaf springs off
a 76 1/2 ton Ford with 3 link suspension.
Front
custom made and bent radius arms for maximum travel and
turning radius
Custom
made and routed brake lines( I even flared them).
Front
Dana 44 and ofcourse rear 9 inch stuffed with 5.14 Yukon gears
Front
crossover steering with rod ends for control off road
Onboard
air I made from the air conditioner unit on the truck with an
in-line 100 psi cut off switch routed to the rear where I made
a square tube bumper for the holding tank
Premiere
Power Welder under the hood for just in case
Throttle
controls in cab for hand control in the bumpy stuff
Welded
front and rears ( don't believe in lockers, an experienced
welder is better any day, aftermarket will make you believe
other).
8000
pound rep Ramsey winch
I
could probably think of much more but when you build every
piece yourself, you can get lost in all you have done.
As
you can see I have put a lot of time and thought in this truck
and I hope you enjoy it.
|