I recently acquired just as the title says, an 86 volvo. It is a 4 door, 4 cylinder, 4 speed electronic overdrive car. Anyone know much about the older volvos?
Whats the largest tire I can fit on my 91 explorer? I have skyjacker leveling coils in the front and 2" lift shackles in the back. I was thinking 33"s with some trimming. Also will my tires 4.0 and A4LD be able to push 33"s with 3:73 gears?
Is there anyone on here who has built a 4.0 OHV to preform? I know tom morona offers stroker kits, cams and such. I just wanna know if anyone has had any luck with them. :dunno:
I just did the throttle body swap on my 88 ranger. I was in the JY today and saw an 87 BII that had the larger throttle body. I snatched the TB then went home and got out my flat file. I knife edged the throttle plate and polished up the bore. It really woke up my old 2.9, I have alot more low...
My 88 ranger has been squeaking alot lately. Particularly from the rear. Whats causing this? Its annoying as heck! Every speed bump it squeaks. I was wondering if it was just the suspension bushings being old and worn/dry rotted. Any help is much appreciated.
Thnx, Marty
After driving my 88 ranger for 6 months now I have a good idea of what I want to do to the suspension. Being that I use it for mild trail use and alot of highway I figure that I wont need anything more than a 31" tire. Remember that this is my DD. I plan on doing a 2" washer lift on the front to...
I was wondering if any of you guys use your ranger for camping? I want to do some this summer. I have 2 camper tops, one is a high rise and one is normal. Both are fiberglass. I put the high rise one on for a little while to see how I liked it, but it was really old and didn't fit well. I put...
I'm not sure what forum to post this in so I posted it here.
I've about had it with the 2 piece drive shaft on my 88 Ex-Cab. About a month after I bought the truck the carrier bearing started to make some noise. I checked it and the rear bearing seal was gone and so was all the grease. So I...
A friend I know at skool offered to trade me some tires and wheels the other day.
The terms of the trade was he was trading me some brand new off brand A/T tires on some deep-dish Outlaw II steel wheels, for my Well Worn 31" BFG Long Trail radials on the same wheels just not deep-dished.
I...
I think the dana 44 is the bench mark for an axle and Ive seen a 10 spline dana 44 hold up to 35" thornturds in a 63 willys, granted it only had a 60 hp, 100 ft.lb tq. F head I4, it still held up and was ABUSED.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.