ok so i got a new truck and i used my ford dealer where i bought the truck to order me running boards.
the truck is an 07 ranger supercab 4 door 2 wheel drive and i want the black runningboards from Ford
The set i have recieved is good except for the rear brackets and i do know from prior posts...
I just bought a 2007 Ranger that is allegedly an XLT ( two of the badges say XLT the other one does not) Anywho I have no factory power windows, locks or mirrors which i thought was standard on an XLT . My question is If i were to get a couple of doors from the1998 up ranger is everything...
I was hit from behind the other day with my ranger. It appears to be driving straight despite the hard hit however the bed appears to sit higher on the passenger side ( which took more of the hit than the drivers side ) and there is slight damage to the cab where the bed hit the cab albeit very...
I had some issues a while back. The trans went and when that happened i realized that my overdrive switch was bad because the overdrive and the reverse lights are on the same circut. The tranny shop determined that thewires in the column were bad and taped em up and the overdrive/reverse lights...
I had done some searching on this site and others regarding this and i figured id post this just in case someone in the future is searching for this info
first off i bought the install kit from ebay and they sent me the kit from American International. there is no part number but it appears to...
OK ill be the first to admit im getting to be a grumpy old curmudgeon, amd things irritate me sometimes more than they should but this kind of irked me and id like your opinions on this and perhaps you could even do what im going to do.....
I walked into two seperate "Cracker Barrel"...
When i bought the truck i noticed it didnt have reverse lights but all other lights worked.I go to check the bulbs and there is no issue with the bulbs and no power to the bulb.
Bright it into inspection and the guy there starts tracing the wires and says that there is no power to the neutral...
Im just wondering because i have an old 1982 C 10 im restoring and have had other square bodies over the years. While i think that Ford makes a far superior truck than anyone else for the last two decades, I liked the older chevies. Anyone on here have any older chevy trucks or are restoring...
I just got this ranger 3.0 and when ihave the air on Max AC ( ive not owned it long enough to know if this is regular occurance )the rear window then the lower part of the windshield and the spots where the vents blow on the side windows get all moisture on them kinda like a fog
I also...
this is the truck i use as a work horse. I bought her brand new with 5 miles on the clock. She now has well over 151K on it and ive been all over the eastern part of the country in her. Shes a 4 cylinder automatic with almost no replaced parts save a timing belt, sway bar links, a couple sets of...
First off let me say that my truck is a work truck and is used daily as just that so its not the prettiest ride out there, but then again neither are some of the trail rigs as they have dents and scratches too.Thes photos are shot with a $20 camera so the quality could prolly be cleaned up...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.