Recent content by steiner_5000

I've been looking for a replacement cubby hole for my 2000 explorer center console but haven't had much luck. Does anyone have any good ideas where I can find one or the part number I could search for it through a dealership?

Ok great! Thanks for the info!

I thought this sounded very odd as well, that's why I wanted to confirm with you guys. I got this idea out of this post : https://www.4btswaps.com/threads/explorer-sport-trac-isuzu-4bd2-auto-to-manual-swap.87441/page-3. Looking post #60 & #71. Sounds like there may have been other underlying...

I'm in the planning phase of doing a diesel swap into my 2000 explorer (small Detroit, 4bt or maybe Isuzu) and I came across a guy who was saying his AC wouldn't run in his sport trac because of the cam position sensor not sending a signal anymore. I would like to keep my AC so is there a way...

I guess that's a really good point only replacing the burned out motor instead of the whole unit. Never thought of that.

I'm building an overlander 2000 explorer and am looking to convert to an electric fan. I would like one that is as near bolt in as possible to the stock radiator shroud. Mainly, I would like something OEM quality that I could find at any local part store in case mine blows out while I'm in the...

Looking for the little storage cubbie hole in the front part of a 2000ish Explorer. Mine got broken and I cant seem to find one online. If you have one or know where I can get one let me know! Thank you

What is the best way to stack them together? Just add one or two of the short springs or maybe add the long one with the ends cut off?

Hello, I'm pretty new to leaf springs and had a couple of questions. I have a 2000 explorer limited and the leaves need replaced. While I'm at it I would like to gain about 2" of lift since I'm replacing anyway but am very frugal so looking at the cheapest way to do this. I have a spare...

I'm getting a PO 401 code on my '97 ranger 4.0. When I start the truck it sputters and chuggs and will hardly drive. But after I let it warm up for a few minutes it clears out and runs just fine. Last summer I replaced the egr valve, solenoid and the DPFE switch when I was having the same...

Im looking for an intake spacer for my 2.9. Any good suggestions on where to find one or am i gonna have to build one?

Im looking at rebuilding the tranny and t-case in my 91' 4x4 ranger and was just wondering how hard is it? Should I just have a pro do it or is it something an average person can handle?

I was looking at rebuilding my 2.9 and was wondering if adding a mild camshaft would harm the fuel milege at all. I know it will improve power but at what cost? Im not looking to build a racing motor I just want to have a fresh motor with some simple upgrades.

Hello I have a 91 ranger with a 2.9 5 speed. I recently swapped the auto transfer case with a manuel t-case. After i did that every time i park the truck I have to disconnect the battery cable or the battery drains dead. Is this problem related to the t-case swap or is there another problem?

Hello My 97 ranger w/ 4.0 sat for a week last week while i was in canada. It started up fine but then the check engine light came on and it idles really rough. It kinda chugs and struggles to stay running. But it accelerates just fine and my fuel economy hasnt been affected either. Any ideas?