Search results

Littlefuse Mega fuse holders and 175 amp fuses. I used these in the dual battery setup on my Ranger. 2 fuse holders, 2 fuses (used but working) and 2 new fuses. Shipped to your door from Georgia for $25.00.

Blue Sea Systems ML-ACR, PN 7622 (with manual control) I ran this for about 2 years, controlling the second battery on my Ranger. It worked great - no issues. This is for the relay, control switch and instructions. I wired in a heavy duty trailer light connector as a quick disconnect for the...

Ford Factory Service Manual for Powertrain Control/Emissions Diagnosis for 1993 Car/Truck. This is the real deal - tells your more about OBD I than you wanted to know! This manual is in great shape - I did not have to use it very much. It was helpful during my 5.0L swap. Shipped to your...

Factory service manual set for Aerostar, Ranger, Explorer. The set includes the Body/Chassis Service Manual and the Powertrain/Drivetrain Service Manual. These are the real deal. I used them to maintain 2 trucks, and they kept my '93 running for over 300K miles. Then, they were beneficial...

My 93 with a 5.0L has been sitting for a while. I have been tinkering with it, and am getting an error code 63. Given the error, and erratic idle, I assumed the throttle position sensor was bad. I put a new one on, and the idle was a little (not much) better. However, I am still getting a 63...

My '93 needs a new fuel pump. Looking at RockAuto, I see a Motorcraft pump assembly for $262, and a Delphi assembly for $75. What makes the $200 difference? What are good brands to buy, and ones to stay away from.? When I did the V8 swap, I learned there was a difference in cheap parts and...

Ford Fuel Injection & Electronic Engine Control book. Covers all EEC-IV systems on Ford, Lincoln and Mercury 1988 - 1993 $25.00 gets it delivered to your door.

Ranger Brochures - 2003 through 2011, minus 2006 These are like new. Nostalgia at its finest! $10.00 gets them delivered to you.

On my Ranger, I have Deaver leaf springs, inverted shackles and I turned the axle shock mounts up so they do not hang down below the axle tube. Needless to say, I get lots of droop travel (30.75" left, 28.75" right). Unfortunately, using a shock that allows for the droop travel eliminates most...

I am about to upgrade my rear Rancho RS9000s to Bilsteins. The question is, will reservoir shocks provide better dampening and control than non-res shocks on a truck that is not a desert racer? I do run in the desert, and enjoy the whoops, but I do not jump or otherwise abuse the truck...

As the title says, my 5.0L is running rich. You can smell it in the exhaust, and the mileage is not great. It starts and runs fine. Currently has 18K miles on it. In my '93 Ranger, I have a '91 Mustang A9P ECU and no EGR. The EGR is bypassed with resistors to stop the computer from throwing...

I am running an AOD behind my 5.0L. It is build quite stout (from Performance Automotive and Transmission Center) with wide ratio gears and a 2500 RPM stall converter. The problem is, when I am going slow (on or off road), the trans climbs through the gears way too fast. It can be in 3rd at...

In an effort to increase the wheel travel of my TTB, I am about to change the shock mounts to F-250 towers and longer Bilstein shocks. I also plan to change the (old, tired) Rancho spring for one with a lower, 300 - 325 lb. rating. The question is, while I am at it, should I raise (or replace)...

I have owned my truck since new (1993) and put an ARE Series 7 shell on it in 2000 - but to date, I have never slept in the truck. All my camping has been in a tent. I planned a 2-week trip to the desert in the spring of 2011. We planned to run the Mojave Road for 3 days, then spend 6 days in...

I would like to replace the headlights on my '93. Searching eBay, etc., finds many replacements. The question is, which one(s) work, and which are junk? I wouldn't mind switching to a project style light if they work. I don't think I will swap in HID - 9007s are pretty bright. I run...

As I work through the final issues of the 5.0L V8 swap, I have a question about my tach. The truck is a '93 (with factory tach). I attached a jumper wire on the back of the tack to convert it to 8 cylinder. The idle speed reads very close to correct. The problem is, as engine speed...

As I am nearing the end of the V8 conversion project, I powered up the computer to test the wiring. (I have not started the engine, yet.) I am using a Ron Davis engine wiring harness - to that, I have adapted the truck's chassis harness. IOW, I am using my original fuel pump circuitry (power...

Seeing as I am about finished with my V8 swap, I find that I have a pile of extra/leftover/not used parts from my donor engine. Is there much of a market for these? I don't necessarily care to get much/any money for them, but I hate to just throw everything away. But, shipping might be cost...

I swapped in a 5.0 in my '93 Ranger, and would like to sell the 4.0. Any idea what it is worth? 1993 4.0 OHV 320,000 miles - runs well, doesn't burn oil Complete exhaust system, including cats. Computer (automatic trans) and engine wiring harness Intake (factory '93 and '95 Explorer for CAI)...

I would like to replace the leaf springs on the back of my '06 Level II. They are sagging. :sad: The truck is not lifted (only a torsion twist to level the front end) and does not see any serious off-roading (I save that for my '93.) I do tow a small boat with this truck. Searching the net...