So I have a 1989 bronco ii Xl v8 302 swap , I was coming down the road my clutch petal got hard as a rock I forced it to the floor it in return popped the hydraulic clutch line out of the transmission . I have tried to put it back into the hole , it's goes in but don't lock in or seat in right ...
Im new here to the forum. My first truck was a 89 ext cab 4cyl manual ranger and was ran over by a semi, second truck was a 94 single cab 4cyl manual ranger and i gave it to my brother when i joiend the AF. 5yrs and 2 kids later, i just bought a 86 ext cab 2.9 6cyl 4x4 ranger and couldn't be...
I just got my 98 ranger so i haven't worked out all the kinks in it yet I found out that the throttel cable on it is longer than it should be an really looks like a cable they would put in a lawn mower...well when i press my clutch in the engine will rev a lot to the point where it sounds like...
Hey i just got my gearbox rebuild on my 99 ford ranger 4x4, and change the throw out bearing but now when the truck is off it shifts in every gear 4 wheel drive and 2 wheel but when the truck is on it only shifts when the 4x4 shifter is in neutral! when i put it in 4x4 none off the gears go in...
while driving i get a loud humming sound it starts out faint then gets louder and faster until it stops. when it does my tach drops from around 1300 right down to about 500 or less sometimes stalling the engine. if i step on the gas it goes away. this seems to happen mostly when i am slowing...
My clutch is starting to grab almost right away when i start to let it out. And when i press in on my clutch it is real soft till about halfway then it feels normal the rest of the way. Also while driving it is hard to shift into any gear, especially 1st and reverse. All these things seem to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.