• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

shift

  1. Manual rebuild, now no 5th gear

    97 Ranger XLT, 4.0 engine, M5oD trans. Did complete drivetrain overhaul a month ago, all went fairly well except now fifth gear won't stay engaged. Had trans all apart, replaced bearings & syncs; reassembly went well, all shifting seemed fine. Get it all back in the truck and first road test i...
  2. 99 Automatic Won't Drive Forward

    Hey, long time reader first time poster. I blew a coolant hose a month ago, coasted a few hundred feet. Pulled into a gravel lot, turned around using little power and parked it. Had to get it towed. When I got the coolant problem fixed, found that it won't move forward in drive it just revs. I...
  3. Transmission overhaul

    Hi fellas, My AL4D is pretty fine except at "coldstarts" being slightly slow to engage. Still as preventative maintenance and to squeeze out some better performance I'm planning on getting a shift kit and new filter. 2 questions: 1: will these parts be all I need next to the tools...
  4. Can't shift into 1st or 2nd gear

    I Recently replaced the clutch system, including slave cylinder, and flywheel on my 1993 Ford Ranger, 4.0L, 5 spd manual transmission. What I’ve done so far: - Removed (shifter, driveshaft, starter, exhaust pipes, transmission, flywheel, clutch, slave cylinder) - Replaced flywheel, slave...
  5. 1990 B2 4wd question

    My 1990 b2 with the push button 4wd was disconected at the button when i bought it. I replaced the button and realized that 2 of the wires going into the back of the button had pulled loose from the harness. Since then, 2 more have pulled loose. Does anyone have a diagram of where the wires go...
  6. please help

    ok...i just bought a truck for my birthday. i got a 2006 ford ranger supercab 2dr 4x4 ,5 spd, 4.0L V6. it drives really nice except for 1 thing, when i shift from neutral to first it clunks, 1st to 2nd it clunks, 2nd to 3rd it clunks, but everything after that is fine...i checked the ujoints by...
  7. BW 1350 Electronic Shift Troubleshooting

    I have been going through my wiring on a '86 BII and got to the point where I was checking the 8-pin connector from Pin 8- Y/W to Pins 4-7. I am showing "Open" on all pins. I went through this multiple times to confirm "Open" at all resistance settings on my multi-meter (.01 ohm-20000 ohms)...

Sponsored Ad


Sponsored Ad

Top