tmaxxman
New Member
- Joined
- Oct 17, 2010
- Messages
- 408
- Reaction score
- 0
- Points
- 0
- Location
- PA
- Vehicle Year
- 1988
- Make / Model
- ford
- Engine Size
- 2.9L
- Transmission
- Manual
ok i parked the 2.9 4x4 1988 5 speed ranger. to put a flywheel in it . it did sit in my garage for about 2 weeks till i got the money and time to go it. but after i got it all back together now it dont want to run good. i can only get about 25 mph out of it in about a 3 blocks. i pulled it back in the garage becouse i had a similar problem before and it was a fuel injector. so i went right to them and i can pull 3 of my fuel injector pluges off the ones on the drivers side and it dont kill the motor down at all. but i pull just one from the passenger side and it kill the motor down. so i had some other fuel injectors out of a parts motor i put in were the 3 that i didnt think were working and still got the problem. so i check the plug to see if they had power the them they do. so just to see i took the ones out of the passenger side and put them on the drivers side and i still have the same problem 3 fuel injectors not working. i made sure all wires are pluged in and vacuum lines were hooked up. any one know were i can look to get this problem fixed i would be very grateful. im at a loss on it i have tried everything i can think of.
Last edited: