4 Low wont engage

[armidapoizon11]

Alright my 4 Low wont go into gear I replaced the tansfer case motor, checked for voltage(there is), I checked and replaced the fuse and I also took the motor off the transfer and left the harness hooked up and had someone run the motor to see if the transfer was bad but thats not the case I have no idea what the problem could be any help would be greatly appreciated thanks

 

[adsm08]

Holy loaded question dude. There are only about half a dozen inputs to the 4x4 module for that shift, any one of which can keep it from happening, as well as the module itself being bad.

 

[Sasquatch_Ryda]

You are in neutral, foot on the brake while trying to engage it, correct?

 

[armidapoizon11]

does the 4x4 module go out often or what cause none of the troubleshooting procedures point towards the module

 

[Sasquatch_Ryda]

• The vehicle does not shift between 4WD HIGH and 4WD LOW modes correctly

• BJB fuse 13 (20A).
• Mode select switch (MSS).
• Neutral safety switch.
• Brake pedal position (BPP) switch.
• 4WD control module.
• Transfer case.
• Digital transmission range (TR) sensor.
• Circuitry.

 

[Kevery]

Sounds to me like you need to put it in neutral. Four low won't engage it park. Just like Sasquatch said.

 

[armidapoizon11]

ok yeah im in neutral of course its a manual trans

 

[Original_Ranger84]

For 4 lo to work on my truck i had to have my foot on the brake, transmission in neutral, clutch all the way in, parking brake on and then turn the knob before it would go into 4lo

 

[CaliNickXLT]

I was having issues with mine then I, Put it into 1st gear, held the clutch and the brake in and then turned it from 4high to 4low and worked perfect. started hopping around the parking lot. Also note im in a 99Xlt 3.0 spd.