- Joined
- Apr 1, 2011
- Messages
- 45
- Reaction score
- 0
- Points
- 0
- Location
- capon bridge wv
- Vehicle Year
- 2000,2002,1978
- Make / Model
- ford
- Engine Size
- 2.9,4.0,4.0
- Transmission
- Manual
need to remove 5 speed from 2002 4x4 4.0 any tips would help.
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
4x4 trans removal tip?
- Thread starter wvranger90
- Start date
- Joined
- Apr 1, 2011
- Messages
- 45
- Reaction score
- 0
- Points
- 0
- Location
- capon bridge wv
- Vehicle Year
- 2000,2002,1978
- Make / Model
- ford
- Engine Size
- 2.9,4.0,4.0
- Transmission
- Manual
and i found orange/white wire to transfer case broke. what does this wire do? i know i need it but i am curious
- Joined
- Apr 1, 2011
- Messages
- 45
- Reaction score
- 0
- Points
- 0
- Location
- capon bridge wv
- Vehicle Year
- 2000,2002,1978
- Make / Model
- ford
- Engine Size
- 2.9,4.0,4.0
- Transmission
- Manual
the wire goes to the stepper motor
Rotagotideas
New Member
- Joined
- Sep 1, 2011
- Messages
- 103
- Reaction score
- 1
- Points
- 0
- Location
- Southwestern Ontario
- Vehicle Year
- 1991
- Make / Model
- Ford
- Engine Size
- 2.9L
- Transmission
- Automatic
tips
check out my tread on how I did my A4LD, http://www.therangerstation.com/forums/showthread.php?t=125177
I know I did an auto and you're doing a stick, but for a stick there are alot of similarities to how the job is done, with a stick you have to disconnect the shifters and the clutch line, I think the clutch line requires a quick disconnect tool. & the clutch & pressure plate only goes on one way. best to replace the clutch & slave cylinder while you have the trans off the truck
check out my tread on how I did my A4LD, http://www.therangerstation.com/forums/showthread.php?t=125177
I know I did an auto and you're doing a stick, but for a stick there are alot of similarities to how the job is done, with a stick you have to disconnect the shifters and the clutch line, I think the clutch line requires a quick disconnect tool. & the clutch & pressure plate only goes on one way. best to replace the clutch & slave cylinder while you have the trans off the truck
Sponsored Ad
Sponsored Ad
Staff online
-
97RangerXLTForum Staff Member
Today's birthdays
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Latest posts
-
-
-
-
-
MAB3L, the most reasonable truck on the road!- Latest: alwaysFlOoReD
-
-
-
Truck of The Month
Mudtruggy
May Truck of The Month
Recently Featured
Follow TRS On Instagram
TRS Events
25th Anniversary Sponsors
Check Out The TRS Store
Sponsored Ad
Sponsored Ad
Sponsored Ad
Amazon Deals
