9 inch in ranger question

[Bryan22]

Anyone know what u-joint i'd need to go from a ranger drveshaft to a 9 inch rear? I'm thinking spicer probably makes some kind of transition u-joint but i don't know which one. any help would be appreciated.

 

[NMB2]

You can get a 1310 Yoke for the 9" so you dont have to use a conversion joint, but if you rather just get the conversion joint, its a 134X. I use them on my truggy to go from my 1310 d-shaft to 1330 yokes on my Dana60's.

 

[Mac]

http://www.therangerstation.com/Magazine/summer2008/ujoints.htm
Down at the bottom! Make sure what you have first, and then what you need - most 9" take the 1330.

Dave

 

[Bryan22]

ya i got that the 9 inch is the 1330, is the ranger a 1310?

BTW thank you guys for the input, i was thinking of also having them take the end off the driveshaft from the bronco and put it on the ranger shaft when i get it lengthened and just use a 1330, but i'm trying to keep it cheap as possible

 

[Mac]

Most have the 1310 but some of the new ext cab are showing up with the smaller 1220 (1210?).
Dave

 

[Bryan22]

thanks again for your help