Edgefevah
New Member
- Joined
- Dec 21, 2012
- Messages
- 219
- Reaction score
- 2
- Points
- 0
- Location
- Calgary Alberta
- Vehicle Year
- 1993
- Make / Model
- Ford
- Engine Size
- 4.0L
- Transmission
- Manual
So I am getting my Ranger supercharged this summer. Right now I have a pic of RPcaster's piece that goes between the Lower Intake Manifold and the supercharger but instead of buying theirs I want to go get my own made.
My initial thoughts are that I could get measurements of all 6 of the pieces myself and get my buddy to weld it together for me. Is this possible? Or do I need to get someone to draw a 3D rendering of the piece in order for someone with a water jet cutter to cut it?
I don't know a whole lot about ^^^this process other then I am just trying to cut out any expenses that I can.
My initial thoughts are that I could get measurements of all 6 of the pieces myself and get my buddy to weld it together for me. Is this possible? Or do I need to get someone to draw a 3D rendering of the piece in order for someone with a water jet cutter to cut it?
I don't know a whole lot about ^^^this process other then I am just trying to cut out any expenses that I can.