Dustin_89BII
Member
- Joined
- Jun 5, 2022
- Messages
- 46
- Reaction score
- 23
- Points
- 8
- Location
- Oregon
- Vehicle Year
- 1989
- Make / Model
- Bronco II
- Engine Type
- 2.9 V6
- Transmission
- Manual
- 2WD / 4WD
- 4WD
Hi folks,
rebuilt a 2.9 and got it installed. Added back the factory ac that’s been missing since I bought the truck.
I have a 2-groove pulley on the crank, but need a 3-groove to run the ac belt in the stock configuration (see pic).
I instead got a smaller belt and have the ac pulley running off of the cam pulley only — instead of crank and cam. I didn’t realize that I need a 3-groove to set it up stock…
MY QUESTION:
Will this be ok from running the Ac compressor or will it cause stress and damage somehow?
thanks!
rebuilt a 2.9 and got it installed. Added back the factory ac that’s been missing since I bought the truck.
I have a 2-groove pulley on the crank, but need a 3-groove to run the ac belt in the stock configuration (see pic).
I instead got a smaller belt and have the ac pulley running off of the cam pulley only — instead of crank and cam. I didn’t realize that I need a 3-groove to set it up stock…
MY QUESTION:
Will this be ok from running the Ac compressor or will it cause stress and damage somehow?
thanks!