RangerReviver1990
Member
- Joined
- Nov 15, 2023
- Messages
- 35
- Reaction score
- 17
- Points
- 8
- Location
- North Carolina
- Vehicle Year
- 1990
- Make / Model
- Ford Ranger XLT
- Engine Type
- 4.0 V6
- Engine Size
- 245 cu. in
- Transmission
- Automatic
- 2WD / 4WD
- 4WD
- Total Lift
- 2’ Leveling Kit
- Tire Size
- 265/75
I was trying to angle my air vent the 4wd buttons out so i could pull the entire panel out its spot to take my trim panel off and I accidentally bent one of the wires where it meets the connector and didn’t think nothing of it. I went to click it back into place and started my truck and the light comes on fully (like, at max brightness like how it’s supposed to be when it’s actually activated) and then it dimmed, but still on. I can’t turn the light off unless i turn the truck off. I even took it out of neutral and clicked the buttons and nothing is happening. This has happens before when I bought it but then the old bulb burnt out and it stopped. I replaced the bulb and thought the issue went away until i kinked the wire. What is happening?