calebrk
New Member
- Joined
- Jan 24, 2008
- Messages
- 78
- Reaction score
- 0
- Points
- 0
- Location
- va
- Vehicle Year
- 1994
- Make / Model
- Ford
- Engine Size
- 4.0L v6
- Transmission
- Manual
I'm dropping the 5 speed trans out of my 92 ranger for the first time. I've got it up on ramps so i have enough room to work underneath. I'm going to take the cross member out that supports the transmission (obviously) but I'm a little concerned the transmission won't fit under the front axle once it's on the floor jack. I'm working in a gravel driveway on a sheet of plywood. Only have one jack so if it won't fit I'm kinda stuck.
Just need to know how tall the bell housing is?
Just need to know how tall the bell housing is?