l0sts0ul
New Member
- Joined
- Jul 15, 2014
- Messages
- 50
- Reaction score
- 0
- Points
- 0
- Location
- Edmonton, AB, Canada
- Vehicle Year
- 1994
- Make / Model
- Ford
- Engine Size
- 3.0L
- Transmission
- Automatic
Hey guys.
I tried dry fitting my engine last night and I ended up feeling completely beaten.
I tried for 2 hours to get the stupid mounts to line up so I could bolt her down and they just wouldn't go... It was like the mounts on the engine were just a bit too wide.
So now I'm thinking I might just put the factory 3.0L mounts in and build the plates, however I'm looking for someone who might have a drawing I could use or at least some decent. Measurements other than 7" for the distance betwen the block holes.
Thanks in advance
I tried dry fitting my engine last night and I ended up feeling completely beaten.
I tried for 2 hours to get the stupid mounts to line up so I could bolt her down and they just wouldn't go... It was like the mounts on the engine were just a bit too wide.
So now I'm thinking I might just put the factory 3.0L mounts in and build the plates, however I'm looking for someone who might have a drawing I could use or at least some decent. Measurements other than 7" for the distance betwen the block holes.
Thanks in advance