fordman49450
New Member
- Joined
- Aug 7, 2007
- Messages
- 266
- Reaction score
- 0
- Points
- 0
- Location
- Michigan
- Vehicle Year
- 1994
- Make / Model
- Ford
- Transmission
- Manual
I am replacing the clutch and flywheel on my 94 ranger 4.0 ext cab 4x4 with M5OD trans. I went to inspect the "pilot bushing" and noticed that there wasnt one in the crank or the flywheel. I did measure the input shaft of the trans and noticed that there is no way it was long enough to ride in the crank pilot hole so I "assume" the pilot bearing is installed into the flywheel? I guess I am asking this to confirm this? my next question would be how far into the flywheel I am to install the bushing? Thanks.