thats the beauty of clones.... you dont have to feed them, just make more!
yah,then they just whine all day.......i'mmmm huuuunngry...wahhhh.
i'll just work alone.
the sleeve with some brackets,ready to tack in place.
and the arm is now held in place.this should make things easier.i set the location of this joint 1/4'' inward of it's proper location so i can adjust it by shimming behind the block plate.
the top mount laid out,ready for drilling.
and held by a temporary brace.now the three points are in place,i can figure clearances better.
from the front you can see there's just enough room to fit the smaller spring and miss the header.