AFStaiger
New Member
- Joined
- Nov 10, 2018
- Messages
- 11
- Reaction score
- 3
- Points
- 3
- Location
- Fresno, California
- Vehicle Year
- 1996
- Make / Model
- Ford Ranger
- Engine Type
- 4.0 V6
- Transmission
- Automatic
- 2WD / 4WD
- 4WD
- Total Lift
- 2” Front
- Tire Size
- 33”
- My credo
- Aim High
Just yesterday I finally get around to wiring up my new stereo. When I first go to start my truck, I hear the speakers buzzing but the stereo is not illuminated, not on. I pull the stereo back out to find the harness adapter I bought had pins in the wrong place. I believe the fused ignition from the stereo was plugged into the always hot line and the always hot line maybe plugged into the ground, possibly plugged into the other battery line. Either way I correct the pins on the adapter and now the stereo turns on just fine but now I’m not getting any noise whatsoever from the speakers. Any ideas? I checked fuse 20 and 29, both were intact