• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

best tire size


rangerkid98

New Member
Joined
Mar 27, 2011
Messages
31
Reaction score
0
Points
0
Vehicle Year
1997
Make / Model
ford
Engine Size
4.0 v6
Transmission
Manual
I have a 97 ranger daily driver that wheels on the weekends and I'm wondering how big of a tire I should put on. I have a 4.0L stick and I want some bigger tires (getting a suspension lift not sure on height yet) but I dont want to make it drive slugglish or have to change any gearing. suggestions?
 


Tony Raine

Member
V8 Engine Swap
Solid Axle Swap
Joined
Aug 10, 2007
Messages
908
Reaction score
17
Points
18
Age
41
Location
Jonesboro, AR
Vehicle Year
1984
Make / Model
Ford
Engine Size
302
Transmission
Manual
33's are about the limit, depending on what gear ratio you have

personally, for a dd, i wouldn't go over 32's.
 

kman

New Member
Joined
Aug 1, 2009
Messages
120
Reaction score
0
Points
0
Location
IN
Vehicle Year
1997/1996
2000
Make / Model
fazda
buell
Engine Size
3.0
Transmission
Manual
i would just get 31s or 32s put explorer springs in the back and a leveling kit in the front with a few washer cheap lift will get about an inch or little more in the back and then just get the leveling spring for the front and add some washers under them to make the front the same as the back
 

Surrey

New Member
Joined
Jan 12, 2011
Messages
1,800
Reaction score
10
Points
0
Location
Vancouver, Canada
Vehicle Year
1989
Make / Model
Ford
Engine Size
2.9
Transmission
Automatic
Depends what gears you have in there now really...

If you have 4.10s, you could run 33s without any issue behind a 4.0l. Maybe even 35s.

Then again, you could have like 3.27 gears at which point 31s are probably too big.
 

4.0B2

Well-Known Member
Supporting Member
TRS Banner 2012-2015
Joined
Sep 24, 2009
Messages
10,700
Reaction score
151
Points
63
Location
Walls, MS
Vehicle Year
1988
Make / Model
Ford
Engine Size
4.0 v6
Transmission
Automatic
33's are sweet for a dd/ww build IMO. i wouldn't want anything smaller. i have 30's and want more (of course).. if you have 4.10's i'd say 33's.. if you don't have 4.10's--- get them. lol
 

rangerkid98

New Member
Joined
Mar 27, 2011
Messages
31
Reaction score
0
Points
0
Vehicle Year
1997
Make / Model
ford
Engine Size
4.0 v6
Transmission
Manual
how much would it cost to go 4.10's? I'm pretty sure there 3.73's right now. and how hard is it to change the gearing?
 

dancron

Member
Joined
Oct 25, 2009
Messages
181
Reaction score
0
Points
16
Location
NJ
Vehicle Year
2005
Make / Model
Ford
Engine Size
3.0 V6
Transmission
Automatic
Depends on where you go. Gears alone are kinda pricey, since yours is 4wd you need to do both sets and they are almost 300 a set then installation.

http://www.jamesoaksenterprises.com/products/ford_75-88_gears.htm

might want to mock everything up before you start going into gearing. your def going to need a leveling kit or something to stuff some bigger tires in there. my 2005 needed a 1 inch torsion crank to fit the 32s in there good.

you may not even have to regear if the tires dont fit
 

RavoHimself

Active Member
RBV's on Boost
Joined
May 5, 2010
Messages
1,084
Reaction score
8
Points
38
Location
enfield, ct
Vehicle Year
2003
Make / Model
Ford
Engine Size
4.0L
Transmission
Manual
more than likely you have 3.73's. i basically have the same truck on 32's with a leveling kit. i think its geared fine. i eventually want to go 33x10.5's and i believe i will still be fine but at 33's i would say 4.10's if you still plan on going off road.
the only time i notice any slow acceleration is on a hill. i just shift a little higher and its fine

so needless to say. i would throw in a leveling kit and go 32's. look at my avatar or in my album for a bigger picture
 

rangerkid98

New Member
Joined
Mar 27, 2011
Messages
31
Reaction score
0
Points
0
Vehicle Year
1997
Make / Model
ford
Engine Size
4.0 v6
Transmission
Manual
no I have 3.27 and they blow ha. once I get the money my friend with a shop is helping me put in 4.10's with a lsd.
 

dancron

Member
Joined
Oct 25, 2009
Messages
181
Reaction score
0
Points
16
Location
NJ
Vehicle Year
2005
Make / Model
Ford
Engine Size
3.0 V6
Transmission
Automatic
might as well do and lsd while youre in there anyway. good luck with it man hopefully it turns out sweet :icon_thumby:
 

RavoHimself

Active Member
RBV's on Boost
Joined
May 5, 2010
Messages
1,084
Reaction score
8
Points
38
Location
enfield, ct
Vehicle Year
2003
Make / Model
Ford
Engine Size
4.0L
Transmission
Manual
well if you're going 4.10's then go for 33's. you're going to need at least 3 or 4" of lift though. should be sweet
 

Sponsored Ad


Sponsored Ad

Staff online

Members online

Today's birthdays

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Latest posts

Truck of The Month


Mudtruggy
May Truck of The Month

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Follow TRS On Instagram

TRS Events

25th Anniversary Sponsors

Check Out The TRS Store


Sponsored Ad


Sponsored Ad

Sponsored Ad


Amazon Deals

Top