Welcome Visitor! Please take a few seconds and 
kiragyu
New Member
- Joined
- Dec 4, 2009
- Messages
- 224
- Reaction score
- 0
- Points
- 0
- Vehicle Year
- 1998
- Make / Model
- mazda
- Engine Size
- 3.0V6
- Transmission
- Automatic
ok guys i did a swap from a 98 3.0 to a 07 4.0 kept the old exhaust well it was hooked up truck revs to 3000rpm but then when you put it in drive it revs fine till you get to 1500rpm then bogs and almost cuts out. i think it is in a limp mode because one of the old o2 sensors doesnt show anything at all and one is just REALLY lazy in switching back and forth. could the 07 computer be in limp mode because its not getting the right data? PLEASE HELP!! ASAP anything you can think of please dont hesitate to post
