85_Ranger4x4
Forum Staff Member
TRS Event Staff
TRS Forum Moderator
Article Contributor
V8 Engine Swap
OTOTM Winner
TRS Banner 2010-2011
TRS 20th Anniversary
VAGABOND
TRS Event Participant
- Joined
- Aug 7, 2007
- Messages
- 32,374
- Reaction score
- 17,933
- Points
- 113
- Location
- SW Iowa
- Vehicle Year
- 1985
- Make / Model
- Ford
- Engine Type
- V8
- Engine Size
- 5.0
- Transmission
- Manual
Anyone have first hand experiance of putting the L/S carrier out of a heep in a TTB D35?
I have read there is a ratio break, is there a chart handy out there for what axle codes mean on a heep to know if it is A) the right ratio B) even limited slip?
Also I read there are other axles in heeps too, what is the best way to pick out a D35 from a D44 or some other far flung axle that I want nothing to do with?
Is pulling the carrier about the same as the 7.5/8.8/9.75 that I have worked on or are there any special tricks? I hate figuring out "special tricks" by the seat of my pants in the JY...
My heeping experience is limited to a few rides and nothing more...
I have read there is a ratio break, is there a chart handy out there for what axle codes mean on a heep to know if it is A) the right ratio B) even limited slip?
Also I read there are other axles in heeps too, what is the best way to pick out a D35 from a D44 or some other far flung axle that I want nothing to do with?
Is pulling the carrier about the same as the 7.5/8.8/9.75 that I have worked on or are there any special tricks? I hate figuring out "special tricks" by the seat of my pants in the JY...
My heeping experience is limited to a few rides and nothing more...
Last edited: