Sdude2008
Member
- Joined
- Sep 11, 2007
- Messages
- 132
- Reaction score
- 18
- Points
- 18
- Location
- Farmington CT
- Vehicle Year
- 1999
- Make / Model
- Ford
- Engine Type
- 3.0 V6
- Engine Size
- 3.0 Flex
- Transmission
- Manual
- 2WD / 4WD
- 4WD
- Tire Size
- 31x10.5x15
1999 3.0 5 spd 129k
Replacing slave and doing clutch while in there. Looking at the pilot bearings from several sources it shows a roller bearing. My crank end has no roller bearing or remnants of a roller bearing. I can see a thin ‘sleeve’ in there with an inside ridge ~ 1/2” in. There is no race or remnants of a roller bearing on the trans shaft either. The photo in the forum repair section doesnt match what I have. Is the roller type something new or am I missing something? TIA.
Replacing slave and doing clutch while in there. Looking at the pilot bearings from several sources it shows a roller bearing. My crank end has no roller bearing or remnants of a roller bearing. I can see a thin ‘sleeve’ in there with an inside ridge ~ 1/2” in. There is no race or remnants of a roller bearing on the trans shaft either. The photo in the forum repair section doesnt match what I have. Is the roller type something new or am I missing something? TIA.
Attachments
-
184.8 KB Views: 45