Eddo Rogue
Well-Known Member
- Joined
- May 18, 2020
- Messages
- 3,982
- Reaction score
- 2,503
- Points
- 113
- Location
- Burbank,CA
- Vehicle Year
- 1993
- Make / Model
- Ranger 4x4
- Engine Type
- 4.0 V6
- Engine Size
- OHV
- Transmission
- Manual
- 2WD / 4WD
- 4WD
- Total Lift
- skyjacker front leveling kit
- Tire Size
- 31-10.50R15
- My credo
- Crossed threads are tight threads.
The other day I noticed my wheel bearings are loose. Its been awhile since I have dealt with non sealed bearings....
Can I repack/tighten them up? I heard these can work themselves loose. They looked ok when I did the brakes about 500 miles ago.
Or should I just replace them? the truck has 87k miles of mostly mellow driving.
If I do replace them, what all do I need? I noticed many options whilst shopping around, and feel I should probably replace seals too.
I have a press. What other parts/special tools would I need or should replace along the way?
Its Dana 35 TTB 3.73's not sure of # axle splines but its under a 4.0ohv extracab xlt model.
Thanks in advance.
Can I repack/tighten them up? I heard these can work themselves loose. They looked ok when I did the brakes about 500 miles ago.
Or should I just replace them? the truck has 87k miles of mostly mellow driving.
If I do replace them, what all do I need? I noticed many options whilst shopping around, and feel I should probably replace seals too.
I have a press. What other parts/special tools would I need or should replace along the way?
Its Dana 35 TTB 3.73's not sure of # axle splines but its under a 4.0ohv extracab xlt model.
Thanks in advance.