- Joined
- Dec 2, 2015
- Messages
- 4
- Points
- 501
- City
- Severna Park , MD
- Vehicle Year
- 2004
- Engine
- 3.0 V6
- Transmission
- Automatic
- Total Lift
- 4" Spindle Lift Front , 3" block lift Rear
- Tire Size
- 31x10.5 Michelin LTX
HI.
2004 Ranger, 2WD, 175,000 miles, all new parts front(spindle, caliper, pads, rotor, abs sending units) & rear(drums, shoes, all hardware, cylinders), and I performed all the pin point test in the service manual. Using the Forscan on the laptop it shows no ABS codes, I did a module reset, but same , no lights on dash, yet ABS module does not do the initial 5 second run when the truck starts moving, and no ABS action, just, as per the owners manual, the regular hydraulic brakes by themselves.
Any clues left to look for?
Thanks
2004 Ranger, 2WD, 175,000 miles, all new parts front(spindle, caliper, pads, rotor, abs sending units) & rear(drums, shoes, all hardware, cylinders), and I performed all the pin point test in the service manual. Using the Forscan on the laptop it shows no ABS codes, I did a module reset, but same , no lights on dash, yet ABS module does not do the initial 5 second run when the truck starts moving, and no ABS action, just, as per the owners manual, the regular hydraulic brakes by themselves.
Any clues left to look for?
Thanks
