The 94 2.3 throttle body has a yellow and black sticker on it that says, "Do not clean the inside of the throttle body." The factory manual says, "The throttle body for this vehicle is a sludge resistant design and should not be cleaned." What's the deal with that? Is the inside of the throttle...
Is using a torch on my 2.3 head to get exhaust bolts out going to damage or warp the head? I'm trying to cover a lot of bases as I begin my engine swap. Thanks.
So a while ago I mentioned that my rough Idle turned out to be low compression in 1 and 2. The leak down showed exhaust valves on those two cylinders to be leaking.
I'm trying to figure plan of attack and looking at my options with 220k on the odometer.
Option 1: Have my cylinder head...
What are the DIY procedures for flushing the system if needed?
I say if needed because my compressor has not failed but I will be removing my engine and taking out the AC components. In this case, is it still necessary to flush the system? I will be replacing the compressor as it is the...
Well I thought I'd share my news. After a lot of poking around I got to the compression check and it's not good. #1 58 psi #2 100 psi #3 150 psi #4 150 psi. I'm off to do a leak down test. :icon_thumby: I hope it's a valve and not rings. Wet test didn't increase it but by a few psi. My guess...
I would love to see some of the layouts you all have for the turbo setups and your supporting components as well. I don't have a turbo Ford, but I would think this would be a great thing to share pictures to show off that favorite turbo. I have a turbo but it's not a Ford. So here goes...
I'm going to be doing my timing belt soon and would like to know if someone could give me a heads up on how this little gem.....
Works with this ..
I didn't use it the last time I did the timing belt and it might have a little something to do with my rough idle...maybe. Anyway any insight as...
I live in California and have a few questions on converters for my 94 2.3L Ranger .
1. Is it legal to replace my own converter or does a shop have to do it?
2. Does a converter have a useful life? I've read they are able to last the life of the vehicle. I have a smog coming up and the last...
This is the removed sensor from the housing. It shows the elements. Note the bottom one is caked with 217,000 miles of deposit.
The next one is after the cleaning. Note the elements are nice and fresh. You can see the contrast from the first picture.
Not that great of a picture, but this...
Is it possible to replace the fuel injectors on a 1994 2.3L without pulling the top half of the intake manifold/throttle body off? It looks pretty tight in there. Also, is there anything I need to get parts wise other than the injectors and o-rings? Thanks!
I'm doing a brake job on my 94 4x2 and replacing the rotors and putting in new inner and outer bearings. The bearings come with matched races. Do I need to use the races that came with the bearings and knock out the ones in the new rotors or will the ones in the new rotors work just fine? What...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.