Trfsrfr
Member
- Joined
- May 27, 2013
- Messages
- 38
- Reaction score
- 1
- Points
- 8
- Vehicle Year
- 1993
- Make / Model
- Ford
- Engine Size
- 3.0
- Transmission
- Manual
I have this 93 that I'm replacing the original clutch master cylinder. I bought the 50 dollar Autozone replacement. The hydraulic hose to the slave is held in by a dowel pin, but it is being stubborn, and theres no room to get something in there to pound it out.
Since the original is a plastic version, I figured I would just take the sawzall or equivalent to the connection bung and hack it off since I cant drive the dowel pin through.
Anybody else done this before?
Since the original is a plastic version, I figured I would just take the sawzall or equivalent to the connection bung and hack it off since I cant drive the dowel pin through.
Anybody else done this before?